S.E.A. Paragliders COCOON RUNA Pilot's Manual page 9

Second, pass the lines through
metal rings on front end of
harness seat board.
Then tie the line to the brummel hook with a bowline knot and attach the speed system to the corresponding
cords on risers of paraglider.
INSTALLING THE DRINK SYSTEM
The Runa harness allows you to install a drinking system.
To install the drinking system, place it in the dedicated compartment in the rear storage pocket. Next, pass the
drinking tube through the opening in the shoulder strap.
FILLING THE INFLATABLE PROTECTOR
The Runa harness is equipped S.E.A. in atable protector. It is located in a special compartment behind the pilot's
back. Thanks to its size and length, it perfectly protects the pilot's waist, back and pelvis. S.E.A. in atable protector
is EN certi ed. The protector can be removed (e.g. for the check or replacing) through a zippered pocket in the
lower part of the harness - just behind the lower pocket under the pilot's knees.
In ate the protector before each ight to maximize its protective properties. You can even use a small electric
pump for this. It is important not to pump up the protector too much. Close the cap on the pipe in 2 seconds after
lling.
After landing, simply open the cap on the lling pipe of protector, the air will out on its own without additional
action. Then you can fold and pack the harness.
Third, route the lines through
both pulleys on the sides of
harness.
Fourth, route the lines through
both eyelets under the
carabiners.
7