Installation The Rescue Parachute - S.E.A. Paragliders COCOON RUNA Pilot's Manual

INSTALLATION THE RESCUE PARACHUTE

Lightweight compact parachutes such as the S.E.A. Paragliders WTF are better suited for Runa harness. It is best to
leave the rescue parachute installation to an experienced instructor or harness manufacturer's representative. It is
very important that the rescue parachute is repacked shortly before being installed in the harness - this directly
a ects the safety of the pilot.
1. Place the inner reserve parachute container with the tied handle next to the harness container. Make sure the
harness and parachute bridles are not twisted. When installing the reserve make sure the reserve handle is up and
the reserve lines are facing down.
2. Guide the Y-bridles of the harness through all covers from the shoulder straps to the rescue parachute position-
ing on the harness.
3. After installing the parachute into the harness, the harness container must be closed with the pins on the
reserve parachute handle. To do this, use the two special packing devices (included in the harness kit), which are
threaded through two loops on the bottom ap of the outer container.
4. Close the top ap.
8. Remove the packing
devices carefully and slowly.
10
5. Close the left ap (in the
ight direction).
9. Pass the plastic cover on
the right side ap through
the parachute handle and
put it into the corresponding
pocket on the left side ap (in
the direction of ight).
6. Close the right ap (in the
ight direction).
7. Pass the lower pin of the
parachute handle through the
lower loop and the upper pin
through the upper loop.