Kenwood TS-711A Instruction Manual page 15

@ DIGITAL FUNCTION
@ Memory
There are 40 memory channels.
M1: Frequency; 144.000 MHz, Mode;
AUTO CW, and Dial; click are the de-
fault values.
M2 ~ M35: Ordinal memory channels.
M36 ~ M38: Split memory channels, i.e., transmit
and receive frequencies can be stored
individually.
M39 ~ M40: The program scan range is stored in
these two channels.
@ Memory contents
Frequency, mode, main dial status (click or continuously
variable), offset, and tone can be stored in each memory
channel RIT status cannot be stored.
@ Memory entry
<M.CH>
M. IN CH. S VFO/M
1. In VFO mode, select the data to be memorized with the
main dial.
2. Set the CHS switch to ON and select the desired me-
mory channel.
3. Press the M.IN switch, and 8 beeps will sound.
Press the M.IN switch again while the beeps are sound-
ing. When memory entry has been performed, the beep
sounds again to verify memory storage.
4. Channels M36 through M38, require input of both
transmit and receive frequencies.
After the RX frequency has been entered the radio will
emit a series of 4 beeps.
Select the desired transmit frequency and then press
the M.IN key. A single beep will sound to confirm entry.
< COM>
M. IN COM
1. Inthe VFO mode, set the data to be memorized with the
main dial.
2. Press the M.IN switch and a double beep will sound and
repeat. Press the COM switch while the beep is sound-
ing. A single beep will confirm entry.
<M.CH data replacement >
M. IN VFO/M
Recall the desired M.CH with the VFO/M switch. If the
stored data except frequency fails, reset the required data.
Press the M.IN switch and beep will sound. Press the M.IN
switch again while the beep is sounding and the replaced
data is stored.
@ SCAN
The scan modes of this transceiver are:
Program scan in VFO; memory scan in M.CH; and mode
scan in M.CH.
@ Program scan
1. In VFO A or B, when the SCAN switch is set to ON,
scan will start within the limits stored in M39 and M40.
When VFO is at a point, scan starts as follows.
a
Lower limit 4145.0
Upper limit
M39
When VFO is at b point, scan starts as follows.
b
Lower limit 145.0 Upper limit
Lower limit 145.0
i
Down scan
* The indicated range is not scanned.
15