Kenwood TS-711A Instruction Manual page 9

TONE SELECT OFFSET
| wove. Ta-7110~ f-—_t- —@)
144MHz TRANSCEIVER
KENWOOD
PROC ALC ATT
oA AES
OFF RF OFF
PHONES
CAUTION:
Do not apply external vol-
tage to these terminals, or
Note: damage will result.
Do not short or apply ex-
ternal voltage to pin 5.
@vup
+8V ©
(less than 10 mA)
@® DOWN
NC ®
@STBY (PTT)
Ground MIC @
@ mic
Ground (STBY)
MIC connector
< Front panel view >
PHONE jack
The headphone jack allows use of a 8 to 16 ohm head-
phone through a 1/4" phone plug.
When phones are used the speaker is disconnected.
@ 8-pin MIC connector
When using a microphone other than the one specified,
connect the ground of the microphone unit to pin @ and
the ground of the standby circuit to pin ®.
@ ATT attenuator switch
@ ALC/RF switch
@ PROC switch
@ RPT switch
@ TONE: Activates tone circuit.
lights.
@ TONE: (For British version)
When this switch is pressed, the repeater
control tone burst signal (1,750 Hz) is emit-
ted for about 1 seconds at the beginning of
each transmission.
@ TONE: (For European version)
When this switch is pressed, the repeater
control tone signal (1,750 Hz) circuit is
activated and the unit is set in the transmit
mode.
Indicates subtone frequency on the display.
Any one of 37 CH's (67 Hz - 250.3 Hz) can
be selected by the main dial. By pressing
the switch again, the display returns to fre-
quency mode.
Used as a tone encoder when the optional
TU-5 is installed.
The T indicator
@ *SELECT:
*SELECT is not applicable to European
users.
Note: