Rear Panel - Kenwood TS-711A Instruction Manual

vows
q
O54
Pus
REAR PANEL
® Indicators
@ STEP: Lights when the STEP switch is ON.
® BUSY: Lights when the center signal is received
with the SQL switch ON.
© REV &LOCK: Lights when the REV & LOCK switch is
ON. :
@ ONAIR: Lights when transmitting.
© DCs: Lights when the DCS switch is ON.
@® CAL: Lights when the C.AL switch is ON.
@ D.sa: Lights when the D.SQ switch is ON.
Note:
When changing the voltage setting, be sure to
Note:
When operating by AC line source, be sure
the dummy plug (8) is connected to its jack,
otherwise the transceiver is not turned on.
® ANT jack
M type antenna jack of 50 ohm impedance.
@ GND terminal
Connect a good earth ground to this terminal.
@® EXT. SP jack
For connecting an external 8-ohm speaker.
@ ST BY switch
When using an external standby switch, use the supplied
plug.
@® KEY jack
For connecting a CW key. Use the supplied plug.
® ACC2 jack
For connecting data communication devices such as
10
use the correct fuse:
@ 2A fuse for 120V
@ 1A fuse for 220V/240V
RTTY, etc. (For details, see page 21.)
ACC1 jack
For connecting a computer interface. (For details, see
page 21.)
@® AC receptacle
AC line input. Use the supplied cable.
DC receptacle
For connecting a DC power source. Remove the dummy
plug and plug in the optional DC cable. Observe polarities
when connecting.
©® Voltage selection switch
Allows selection of three different voltages, 120V, 220V
and 240V.