Cancelling Devices (Main Monitor/Extension Monitor) - Panasonic VL-MW274 Operating Instructions Manual

9. Expanding the system
When repeaters are used:
9.2.1 Registering repeaters
1
Main monitor:
N ® select "Register/Cancel" ®
M
2
Select "Register" ®
R If you are prompted to register your main monitor,
select "Main monitor" ®
3
Select "Repeater" ®
4
Select the number of the repeater to be registered
®
.
R Complete the following operations within about 2
minutes.
5
Repeater:
While the power is on, press and hold
MPROGRAMN (A) for about 3 seconds.
R The STATUS indicator (B) flashes in green.
R After completing the registration, the indicator
lights up solid.
B
6
Main monitor:
Press M N.
Note:
R If you register two repeaters, please separate them
more than 3 meters to avoid electrical noise.
R When using devices in separate buildings or over
long distances, cut outs and image distortions may
not be improved even if a repeater is used.
9.3 Cancelling devices (main
monitor/extension monitor)
1
N ® select "Register/Cancel" ®
M
28
.
.
.
.
PROGRAM
A
.
2
Select "Cancel" ®
3
Select the type of device to cancel
4
Select the device to cancel
.
R A beep sounds and "Cancel completed" is
displayed.
*1 Not displayed when using as an extension monitor.
Important:
R To prevent incorrect operations, remove the
batteries from cancelled sub monitors.
Note:
R When you want to change an extension monitor's
registration number or re-register an extension
monitor, first use the extension monitor to cancel
itself, and then re-register it again as an extension
monitor. (Extension monitors become main monitors
again when they are cancelled.)
.
*1
®
.
*1 *1
® ®