NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fi xed on a wall using the fi xture provided. Before fi xing it, make sure the indoor unit
can be controlled from the remote controller.
●
Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
●
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
●
START/STOP button
Press this button to start operation. Press it again to stop operation.
●
SLEEP button
Use this button to set the sleep timer.
●
TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
●
TIME button
Use this button to set and check the time and date.
●
RESET buttons
●
FUNCTION selector
Use this button to select the operating mode. Every time you press it,
the mode will change from
to
(COOL) and to
●
FAN SPEED selector
This determines the fan speed. Every time you press this button, the
intensity of circulation will change from
(LOW) (during the
●
AUTO SWING button
Controls the angle of the horizontal air defl ector.
●
TIMER control
Use this button to set the timer.
●
OFF-TIMER button
●
ON-TIMER button
●
RESERVE button
●
CANCEL button
Precautions for Use
●
Do not put the remote controller in the following places.
●
Under direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the fl oor,
and protect it from water.
●
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
●
If you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
(AUTO) to
(FAN) cyclically.
(FAN) mode, from
Select the turn OFF time.
Select the turn ON time.
Time setting reservation.
Cancel time reservation.
– 10 –
(HEAT) to
(DEHUMIDIFY)
(AUTO) to
(HI) to
HI to
MED to
(MED) to
LOW).