Table of Contents
Advertisement
ATTACHING THE AIR PURIFYING FILTERS
CAUTION
!
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1
Open the front panel.
Pull up the front panel by holding it at both sides with
●
both hands.
2
Remove the pre-fi lters.
Push upward to release the claws and pull out the
●
pre-fi lters.
3
Attaching the air purifying fi lters.
Attach the air purifying fi lters to the frame by gently
●
compress its both sides and release after insertion
into fi lter frame.
!
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
4
Attach the fi lters.
Attach the pre-fi lters by ensuring that the surface
●
written "FRONT" is facing front.
After attaching the pre-fi lters, push the front panel at
●
three arrow portion as shown in fi gure and close it.
NOTE
In case of removing the air purifying fi lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
●
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying fi lters are not washable. It is recommended to use vacuum cleaner to clean it. It can be
●
use for 1 year time. Type number for this air purifying fi lter is <SPX-NTW1>. Please use this number
for ordering when you want to renew it.
Do not operate the air conditioner without pre-fi lters. Dust may enter the air conditioner and fault
●
may occur.
CAUTION
Claws
(4 places)
– 24 –
Advertisement
Table of Contents
