Release History - GE PROFINET PACSystems RX3i Quick Start Manual

IC695PNC001-AJ PROFINET Controller Module

Release History

Version Firmware Revision
IC695PNC001-AJ
IC695PNC001-AH
IC695PNC001-AG
IC695PNC001-AF
IC695PNC001-AE
IC695PNC001-AD
IC695PNC001-AC
IC695PNC001-AB
IC695PNC001-AA
Date
2.11 Feb. 2015
2.05 June 2014
2.00 Dec. 2013
1.23 Aug. 2013
1.22 Jul. 2013
1.21 Jul. 2012
1.20 Mar. 2012
1.10 Dec. 2011
1.00 Jun. 2011
Increased number of Profinet Devices that PNC can control from 64
to 128. Still limited to 63 devices in an MRP Ring if the PNC is the MRP
Ring Manager.
Added new "SFP OK" status bits to existing PNC status dword.
Introduced new "Critical Network Port" diagnostic fault configuration
and logging. Configuring ports as critical also forces Cu ports to
100 Mbps.
Adds support for Genius Communication Gateway (GCG001) module
(COMMREQ support)
Adds remote PROFINET IO to PACSystems RX3i Hot Standby
Redundancy systems. Also adds MRP status bits.
For details, see "New Features and Enhancements" on page 8.
Corrects issue storing PROFINET device configuration greater than
64K bytes in size.
For details, see GFK-2573F.
Corrects an issue where, in some configurations, the PNC entered a
mode that caused it to repeatedly power up.
Addresses a power up issue affecting the following revisions
IC695PNC001-AB and IC695PNC001-AC.
Although no units that exhibited this issue were shipped, it is
recommended to update firmware to prevent the possibility of
encountering a power up issue in the field.
Adds support for up to 255 PROFINET IO Devices per RX3i CPU.
Adds support for SNMP and LLDP standards to facilitate network
management.
Provides enhanced Revision Information in the Explore PROFINET
Networks tool.
Initial release.
Supports GSDML Version 2.2 and previous.
Comments
7
GFK-2573K