Table of Contents
Advertisement
TROUBLESHOOTING
Incorrect operations are often for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Inspect the other components
and electri
appliances being used.
!f the trouble cannot be rectified even after execising the checks listed below, ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
SYMPTOM
CAUSE
REMEDY
1. Disc table is not ejected when
OPEN/CLOSE is pressed.
Power cord is not properly plugged into AC wall
socket.
Power switch is not turned on.
Plug in power cord.
Turn on power switch
2. Disc table comes out.
Disc is dirty.
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
Disc is warped.
.
Clean disc.
Set the disc properly.
Remove disc and fet player stand for 1
to 2 hours until it is dry.
Try to alleviate
the warp.
(Refer
to
Symptom 9, remedy column.}
ol
. TV no longer receives other
channels after it has been
connected to the player.
Antenna cable has not been connected.
LDP mode is selected.
Connect VHF antenna cable to antenna
terminal on the player.
Select the TV mode by pressing TV/
LDP or turning off the player's POWER.
4. Slanting strises appear on the
TV sereen when TV/LOP is
pressed to receive TV
broadcasis.
Electric field for TV broadcasting is week.
{This does not indicate eny trouble.)
Turn off POWER of thie player.
We
recommend
that
you
turn
off
POWER of the player, whenever you
intend to watch TV for a long time.
5. Remote control does not work.
|e
The CONTRO!
connected to
control center.
Batteries are weak.
There is an obstacle between the player and the
remote contro! unit.
Remote control unit is not in a good location for
transmission
IN terminal on the rear panel is
Neer prajection monitor
or AV
Aim
the remote
contre!
unit at the
projection monitor or AV control center.
Replace batteries.
Remove
the
obstacle
or
shift the
remote control pasition.
Operate the remote control unit in front
of the player.
6. Operation of the remote control
unit causes the TV to operate
irnproperly.
Some TV sets have remote control functions that
operaie
improperly
in response
to the
remote
control unit of the player.
Move the TV and the player further
apart, or cover the remote sensor of
the TV during dise playback.
34
<VRB1037>
Advertisement
Table of Contents
