Rtsi Connector Pinout; Usb Device Led Patterns - National Instruments PXIe-6355 User Manual

Figure 3-2. Connecting to the Disk Drive Power Connector
1 Device Disk Drive Power Connector
4. Replace the computer cover, and plug in and power on the computer.

RTSI Connector Pinout

x x
(NI PCIe-632 /634
Chapter 9, Digital Routing and Clock
PCI Express X Series devices.

USB Device LED Patterns

x x
(NI USB-634 /635
READY. The ACTIVE LED indicates activity over the bus. The READY LED indicates
whether or not the device is configured. Table 3-2 shows the behavior of the LEDs.
POWER ACTIVE
LED* LED
Off or On
On
On
On Blinking
* USB BNC devices only.
1
x x x
/635 /636 /637 Devices)
Generation, for information about the RTSI connector on
x
/636 Devices) USB X Series devices have LEDs labeled ACTIVE and
Table 3-2. LED Patterns
READY
LED
Off Off
Off On
On On
On
2
2 PC Disk Drive Power Connector
Refer to the RTSI Connector Pinout
USB Device State
The device is not powered or not connected to the
host computer, or the host computer does not
have the correct version of NI-DAQmx. Refer to
Table 2-4, X Series NI-DAQmx Software
Support, for the NI-DAQmx support information
for your device. Detection can take 30 to
45 seconds.
The device is configured, but there is no activity
over the bus.
The device is configured and there is activity
over the bus.
X Series User Manual
section of
© National Instruments | 3-7