Advertisement
MIRAGE
8-34-G
instruction Manual
@ EXPLANATION
OF FEATURES
*PRE-AMP PILOT LAMP
The RX pilat lamp will illuminate when the pre-amp
is engaged. The pre-amp can be used independently
even if the amplifier's power is off.
*POWER ON PILOT LAMP
if the lamp is in the off position the amplifier will pass
the RF in a straight through mode. This means that both
*ON AIR PILOT LAMP
the receive
and transmit signal will bypass
the internal
The ON AIR pilot lamp
cireultry of the amplifier. f the lamp Is illuminated then
indicates the amp is
the amplifier is in the standby mode and will amplify any
transmitting
signal that is supplied to its input of more than 1 watt.
on the air.
VHF LINEAR
AMPLIFIER
wkSieie
i
eae
ey
we
w~
w
SSB
—
e
Fra
FF
ore
=
MIRAGE
-
B-34-G
2-Meter
Fower
Amplifier
144-148 MHz
With GaAsFET Pre-amp
When in the SSB mode the
amplifier will delay the changeover time
of the carrier operated transmit retay fo
1 second before disengaging.
This will prevent
relay chatter as a
result of working SSB or CW. in the FM
mode the retay will operate normally ~
*POWER ON SWITCH
and disengage
once the transmit signal is dropped.
When engaged, the amplifier
is ready to amplify any
al applied to
*PRE-AMP SWITCH
ove piastie Joitinies
When engaged the amplifiers pre-amp will be switched
into the circuit for recaive. A sansing circuit will disengage
fhe pre-amp when a transmitted signal is appiied to the ampilfier's input.
The pre-amp may aiso work independently if the amplifiers main power switch is off.
2
MIRAGE
8B-34-G instruction Manual
B® EXPLANATION
OF FEATURES
The coax from your antenna
is connected fo this port.
ANTENNA
13.8V DC
@
s
MIRAGE
ATICH EQUIPMENT
\ DC PWR (13.8)
This port has two wires.The Red wire is
for positive and incorporates a FUSE holder,
The Black wire Is for negative.
* RADIO (RF INPUT)
The Mirage B-34 amplifier will accept
The coax from your radio
voltages of 12 fo 15 volts DC.
or exciter is connected to
this port.
Advertisement
