Advertisement
4. Slide
the two Handlebar Collars (7) onto the Left
Handlebar (50). Insert the Right Handlebar (51) into
the Left Handlebar. Connect the Handlebar Collars, the
Left Handlebar, and the Right Handlebar with two M4 x
16mm Screws (66).
Attach the Handlebar Bracket (15) to the Left and
Right Handlebars (50, 51) with four M8 x 22mm Button
Screws (74).
Attach the Handlebar Bracket (15) to the Upright (13)
with two M8 x 39mm Button Bolts (64), two M8 Nylon
Locknuts (10), and an M8 x 14mm Button Screw (49).
5. While another person holds the Console (16) in the
positionshown, connect the wire harness on the
Console to the Upper Wire Harness (36). Insert the
excess wire harness into the Updght (13).
Attach the Console (16) to the Upright (13) with four
M4 x 16mm Screws (66). Be careful to avoid pinch-
ing the wire harnesses.
6. The Console (16) requires four "D" batteries (not
included); alkaline batteries are recommended. Pull
the battery drawer open. Insert four batteries intothe
battery drawer. Make sure that the batteries are ori-
ented as shown by the markings inside the battery
drawer. Close the battery drawer. Note: When the bat-
teries are installedcorrectly, the fan will turnon for a
moment.
7. Turn the indicatedAdjustment Knob (28) counterclock-
wise two or three turns to loosen it. Next, pull the Knob,
insertthe Seat Post (5) intothe Frame (1), and then
release the Knob. Move the Seat Post up and down
slightly until the pin on the Knob snaps into one of
the holes in the Seat Post. Then, turn the Knob clock-
wise until it is tight.
4
5
6
7
66
51
66
Wire
Harness
1\
16
Batteries
Drawer
7
Advertisement
