Cleaning And Care; Cleaning The Steam Nozzle - Beem CM5418C-GS Manual

EN

Cleaning and Care

PLEASE NOTE!
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
•
the device. These may damage the surface.
1. Take the portafilter (9) out of the device and empty it (see the "Preparation" chapter –
"Removing the Portafilter from the Device").
2. Remove the used sieve insert (7, 8) (see the "Preparation" chapter – "Inserting / Removing
the Sieve Insert").
3. Empty the drip tray (10) after each use (see the "Preparation" chapter – "Inserting / Removing
the Drip Tray").
4. Clean all used accessories with detergent and warm water.
5. Wipe the housing with a damp cloth. If necessary, use a little detergent to remove more
intense soiling.
6. Check the connecting cable regularly for any damage.

Cleaning the Steam Nozzle

To prevent any blockage, the steam nozzle (5) must be cleaned after each use.
1. Turn the steam nozzle over the drip tray (10).
2. Switch on the device by pressing the
mode. The control lamp
(19) flash.
Once the preheating has ended, all control lamps are constantly lit.
3. Move the steam power control (4) to position
milk residues are rinsed out of the steam nozzle.
4. Turn the steam power control to the OFF position to stop emitting water.
5. Wipe down the steam nozzle with a damp cloth.
If the steam nozzle has become clogged, you can release the blockage with a needle.
button (16). The device switches to preheating
is lit constantly and the control lamps (17),
. The device starts to emit water and
36
(18) and