Table of Contents
Advertisement
KV-20/13VM30/31
RM-Y138/W
- REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and anode cap to the metal chassis, CRT shield or carbon
painted on the CRT, after removing the anode.
CAUTION:
Anode-cap must be removed after discharge.
REMOVING PROCEDURES
Anode button
@ Turn up one side of the rubber cap
@ Using a thumb, pull up the rubber
@) When one side of the rubber cap is
in the direction indicated by the
cap firmly in the direction indicated
separated from the anode button,
arrow @).
by the arrow ©.
the anode-cap can be removed by
turning up the rubber cap and
pulling it up in the direction of the
arrow ©.
HOW TO HANDLE AN ANODE-CAP
@ Don't hurt the surface of anode-caps with sharp objects.
@ Don't press the rubber or you will hurt the inside of the anode-cap.
A material fitting called as shatter-hook terminal is built in the rubber.
@ Don't turn the foot of rubber over hardly! The shatter-hook terminal will stick out or hurt the rubber.
-
384 -
Advertisement
Table of Contents
