Advertisement
3-1
DISMANTLING HINTS
Dismantling of Front
Service position monoboard
Dismantling of mono board
1) Remove
front . See picture 1
2)' Remove
whole front (disconnect the wires on the mono
board coming from front)
1) Bring front in position as shown in picture 6
2) Snap nok of front in bottom to make front stable . See picture 7
3) Connect front wiring back to monoboard.
*The tuner module doesn't have to be connected. Use an other source (pe.CD)
picture 7
picture 1
1) Remove top cover
2) Remove power rod
3) Remove 6 x screw as shown in picture 1
4) Release two snaps (left & right side front)
5) Release two snaps on the bottom side front
6) Tipp down front as shown in picture 2
ay
picture 4
4) Remove wires out the cable-sleeve.
5) Remove 7 x screw
and remove metal bracket
)
6) Remove 2 x screw on mono board . See pictue 4
7) Remove mono board as shown
arrow 1 & 2. See picture 4
;
dt
8) Bring the mono board in the service position as shown in picture 5
1) Put main trafo as shown in picture 9
picture 9
picture 2
Handling service cover
Dismantling of mainstrafo
picture 5
Legend
C)
C)
;
pEture 10
picture 8
a=
= Torx M3x6mm ( screw with big head )
dRatiove powers
1) To open the service cover cut 14 x lugs between cover and bottem . Sex piccture 10 (\/)
a
Sen axiomin
a
= Torx M3x6mm
2) To close the service cover put 11 x screw in mentionned holes. See picthre
10
2) Remove
4x screw as shown in picture 8
a=
>
; Cs
Service codenumber 12x Torx M3x6mm screw with big head = 4822 502 le&»9
Advertisement
