Advertisement
|
1
|
a
i
i
i
4
5
i
2 haan
INSTRUCTIONS FOR USE
You can search for radio stations by scanning the frequency
band. You can also key in the frequency of a known radio
station. If an FM station is being broadcast and received in
stereo, STEREO is shown.
Searching for radio stations
1 Turn SOURCE SELECTOR to select the tuner.
—» TUNER is displayed.
2 Select a waveband by pressing TUNER AM/FM repeatedly.
-»The selected waveband is displayed.
3 Keep < or > pressed for approximately 1 second.
—»SEARCH is displayed and the tuner tunes to a station
with sufficient strength.
4 Repeat this procedure until you find the desired station.
* To fine tune to a weak transmitter, briefly press <€ or P as
often as necessary for optimum reception.
Tuning to a radio station by frequency (with the remote
control only)
1 Press TUNER.
_ ~p TUNER is displayed.
2 Press FR. D..
~»_ is displayed.
3 Use 1-0 to key in the frequency of a radio station.
Note: Only valid numbers within the frequency range of the
tuner can be keyed in.
You can switch the tuner to a lower search sensitivity, to
search only for stations with a strong signal (FM only).
1 Turn SOURCE SELECTOR to select the tuner.
—» TUNER is displayed.
2 Press SENS. on the receiver.
~» Either SENS HI Or SENS Lo is displayed for 5 seconds.
Note: While searching for radio stations, the actual sensitivity
is displayed. In this case, SENS LO means the tuner is
only leaking for radio stations with a strong signal.
TUNER
You may store up to 30 radio stations in the memory. The
receiver can select and program radio stations by itself or you
can choose them yourself.
Automatic programming
1 Choose * TUNER from the menu and press NEXT P.
2 Choose AUTO INSTALL and press NEXT >.
—» The preset number where programming will start, the
waveband and ALTO are displayed.
3 Turn TUNER PRESET # to change the preset number where
programming should start.
4 Use TUNER AM/FM to switch to the desired waveband.
5 Press ENTER / OK to start programming.
—eAUTO
INSTALL flashes and all available radio
stations are programmed, this may take a few minutes.
Programming is done when AUTO INSTALL stops
flashing.
Manual programming
1 Choose ¥ TUNER from the menu and press NEXT >.
2 Choose MAN INSTALL and press NEXT >.
—»A preset number, the waveband and the frequency are
displayed.
3 Turn TUNER PRESET $ to change to the preset number
where the radio station should be stored.
4 Tune to the desired radio station (see "Searching for radio
stations").
5 Press ENTER / OK to confirm your selection.
—»5STORET
is displayed briefly. The radio station is
programmed at the chosen preset number.
& Select and store all desired radio stations this way.
PCS 105 717
Advertisement
