Advertisement
2-4
INSTRUCTIONS FOR USE
REMOTE CONTROL
inscription Multibrand/Universal.
PON Oi 2 cees terse ateo marca: 2
The universal remote control must be programmed to use the
codes for your appliances of different brands. This is done by
TINE yi eetsatptesstedseintes Pexeesnieicetece
keying in a 4-digit code or by scanning the codes until the
correct one is found. We recommend to using the 4-digit
EB Spee aren Se
an ona
ey ere
code. This methad is faster and more reliable. The code
scanning method should only be used if you cannot find the
CORT ARE cc esdateieesiseataec
abies
code for one of your appliances. The code table can be found
at the end of the booklet.
AN cece Acsicinsaan Weta tesiteatatapoire'lales ct 22
Important!
WG ape iees
teeuare net.
The buttons of the remote control must be used for
programming, not the buttons of the receiver or other
A
Aces ccetenek testa
Oe hacen ak he
appliances.
DV Bi hal encase een indhe ne eateaeiede
Programming with the 4-digit code
1 Keep the source button for the appliance which should be
Resetting the remote control
controlled and(!) pressed for 3 seconds,
1 Keep one of the source buttons and C pressed for 3
seconds.
2 Key in the 4-digit code for the appliance (codetable at the
end of the booklet).
2 Key in the 3-digit code 981.
-»The remote control is now reset to all its original Philips
Notes: —/f more than 4 digits are entered, the remote
codes.
control will recognize only the ones keyed in first.
— If you do not key in a code within 30 seconds the
remote control will switch off the programming
function without changing the code.
~ To program a new appliance, simply overwrite the
old code by entering a new one.
Scanning the codetable
1 Switch on the appliance which should be controlled.
2 Keep the source button for the appliance which should be
controlled and() pressed for 3 seconds.
3 Press and release (4 again.
-»The remote control sends the codes for channel up or
standby (depending on the selected source} for one
brand after the other.
4 As soon as the appliance reacts — switches to the next
channel or to standby ~ press () to confirm the cade.
~» The identified code will be used.
* If the set does not react within 2 minutes, the code for this
appliance is not stored in the remote control. The code of
the remote control will remain unchanged.
Note: When taking out the batteries of the remote control for
more than 1 minute the codes must be reprogrammed.
| PCS 105 704
Advertisement
