Cold Start Button; Idle Speed Adjusting Screw; Shift Lever - GAS GAS EX 250 2023 Owner's Manual

6.11

Cold start button

6.12

Idle speed adjusting screw

6.13

Shift lever

The cold start button
The electronic fuel injection system extends the injection time if the
engine is cold and the ambient temperature is low. To help the engine
burn the increased fuel quantity, it must be supplied with additional
oxygen by pulling the cold start button.
Info
If the engine is warm, the cold start button must be deactivated.
Possible states
E01992-11
The cold start button is activated – The cold start button is pulled
•
out all the way and turned by a ¼ turn.
The cold start button is deactivated – A further ¼ turn returns the
•
cold start button back to the basic position.
The idle setting of the throttle valve body substantially influences
the vehicle's starting behavior, a stable idle speed, and the vehicle's
response when the throttle is opened.
An engine with a correctly set idle speed is easier to start than an engine
with the idle speed set incorrectly.
The idle speed is adjusted using the idle speed adjusting screw
Info
If the idle speed is high, the engine is slow to run, the engine
brake is low and the throttle response is aggressive, the adjust-
E01992-10
ment screw must be turned clockwise.
If the idle speed is low, the engine is running fast, the engine
brake is high and the throttle response is not clean, the adjusting
screw must be turned counterclockwise.
1
Shift lever is mounted on the left of the engine.
401950-10
The gear positions can be seen in the photograph.
The neutral or idle position is between the first and second gears.
401950-11
1
is fitted on the side of the throttle valve body.
CONTROLS 6
1
.
17