Table of Contents
Advertisement
Programming
the Remote Control
• This Remote Control is preprogrammed
to operate TOSHIBA VCRs.
• "To use VCRs other than TOSHIBA
models (or Cable converter),
perform
the following
procedures
before operating.
o@@l
STOP
NEW
PLaY
FF
®
I
W
-_
POWER
I
RECALL
---
Number
buttons
For future reference, write the code
you used.
VCF',CODE:
.2
CABLE CODE:
1
Refer to the "VCR code table"
(or "Cable TV converter code table")
on pages 14 and 15 to find the code number that co,responds
to the
brand name of your VCR (or your converter).
If more than one number
is listed, try each one separately
until you
find the one that works.
2
3
Set the TV/CABLE/VCR
switch to "VCR"
(or "CABLE").
Hold down RECALL while pressing
the Number buttons for the three
digit code number
for your brand of VCR (or converter).
-
The transmit
indicator
lights up for 1 second when the programming
is completed.
4
When an operation
error has occurred,
the indicator
blinks.
Press RECALL again to reset.
Point the Remote Control at the VCR (or at the converter)
and press
POWER to test the code number.
- If the right number was entered, the VCR (or t_e converter)
should
turn on.
- If the VCR {or the converter)
does not respond
to the Remote
Control,
repeat steps 1 to 4 with another code number.
Notes:
• You have to reprogram
the Remote Control when ,/or. change its
batteries.
• Some newer VCR's are capable of 'working on either of two remote
codes;. These VCR's have a switch labeled "VCR1/VCR2".
If your VCR has this kind of switch, and does not respond to any of the
code numbers for your VCR brand name, set the switch to another
position
("VCRI"
or "VCR2") and reprogram
the Remote Control.
Z
m
0
0
0
E
,r,.
°_
E
E
9
€-
o
€-
o
11
Advertisement
Table of Contents
