Table of Contents
Advertisement
Installing your TV Set
- Where
to install
Place the iV on the floor or on a sturdy platform.
The mounting
surface: should be flat and steady.
Lighting
Do not place the TV in a room where direct lighting
strikes the screen. Use soft and indirect lighting.
Air circulation
--"Place the IV far enough from the walls to allow
proper ventilation. This will prevent the "IV from
- overheating
and avoid possible damage to the TV.
Avoid dusty places too.
Power
supply
Plug into an electrical
outlet with standard house-
hold power (120 volt AC, 60Hz). Do not change the
plug's safety prong. See the right column.
WARNING
:
TO AVOID
PERSONAL
INJURY
• Do not stand or climb on the 2-V.
• Do not put a VCR or any hea_¢ object on top of
the TV.
CAUTION
:
As a safety feature, the plug ha,; one prong wider
than the other. It will fit only one way into a stand-
ard electrical
outlet. If the plug will not fit into the
outlet, try turning
it around, tf the plug will not fit
either way, the outlet is probab y old and non-
standard.
You will need to
Wide prong
have a new outlet
installed by an
electrician.
DO NOT CHANGE
THE SAFETY
FEATURE OF THE
PLUG.
Antenna/Cable
TV General Information
i
i
You can use either an indoor or outdoor
antenna to receive VHF and/or UHF channels.
Channels 2 - 13 are VHF channels,
and channels
!4 - 69 are UHF channels.
'We recommend
using an outdoor
antenna for better picture quality.
'You can receive Cable -IV by connecting
the cabie supplied
by your local cable company.
Cable TV delivers
both VHF and UHF channels and other channels
not available
to your antenna.
Shown below are two basic types of antenna cables.
Signals from a home antenna
may be conveyed
by either
type. Cable TV signals will always be conveyed
by a 75
ohm coaxial'cable.
-1
A 75 ohm coaxial cable is generally
a round cable
with an F-type connector
that can easily be attached
to a terminal
without
tools.
F-type connecto, r (Not supplied)
2
A 300 ohm cable is a flat "twin-lead"
cable that can
be attached to a terminal
using an antenna adapter
supplied
as an accessory.
C
There are two separate 75 ohm F-type connector
termi-
nals and a converter
output terminal
as shown
below.
@©©
ANT-1
OUT
ANT-2
The ANT-1 and ANT-2 terminals
a_'efor connecting
a
VHF/UHF antenna or a cable TV system. The signal,
which
is input through
the ANT-1 Eerminal, is also output
from the OUT terminal
whenever
:he antenna ir_put is set
to the ANT 2 mode. You can switch
between the ANT 1
and ANT 2 modes by pressingthe
ANT 1/2 button on the
Remote Control or the ANT/VIDEO
button on the -IV. See
page 16.
4
Advertisement
Table of Contents
