Replacing The Cross Fader - Roland DJ-2000 Owner's Manual

Replacing the Cross Fader
When replacing the Cross Fader, remove only the two outer screws holding it in place.
Make sure to switch off the power, and pull the plug from the outlet before beginning.
Do not touch any of the printed circuit pathways or connection terminals.
To avoid injury, be very careful around the opening's edges and near the circuit board.
Unscrew and remove only the two outer screws.
CROSS FADER
Procedure
1. Switch off the power to the unit.
2. Unscrew and remove only the two outer Cross Fader attachment screws.
3. Unfasten the connector from the Cross Fader unit.
4. Plug the connector into the new Cross Fader unit.
5. Replace and fasten the unit as before.
* When circuit board installation is complete, double-check your work.
* When you wish to purchase the Cross Fader for replacing the DJ-2000 (CFX-1), please ask the retailer shop where you
bought this unit.
20