Sony Trinitron WEGA KV-27FV15 Operating Instructions Manual page 38

Hide thumbs Also See for Trinitron WEGA KV-27FV15:
Table of Contents

Advertisement

Consult the table below; it suggests solutions to specific problems.
Problem
You want to restore the TV's
factory settings
What it could be
A red light keeps flashing on the
TV for more than a few seconds
TV makes a noise when turned on
Screen is not lit and there is no
sound
Poor or no picture (screen lit),
good sound
What you can do
¢ First, turn the TV on. Then while pressing the RESET
button on the remote control, press the POWER button
on the TV. The TV will turn itself off and then back on.
When the TV turns on again, all settings will be reset, and
the initial setup screen will appear.
Your TV may need service.
|
This is a normal function of your TV.
* Call your local Sony service center.
Power cord may not be plugged in.
Remote control batteries may not be inserted correctly.
TV/VIDEO setting may be incorrect.
Current program may exceed PARENTAL
CONTROL
settings.
Check your power cord.
Re-insert the batteries in your remote control.
Press TV/VIDEO until you receive a channel.
Check your PARENTAL CONTROL settings, (page 28).
VIDEO menu settings may not be adjusted correctly.
Antenna/cable connections may be faulty.
¢ VIDEO LABEL inputs may be set to WEB. (This
label darkens the screen for ideal WebTV viewing)
¢ Readjust your VIDEO menu settings, (page 19).
¢ Check your VIDEO LABEL settings, (page 22).
Good picture, no sound
Sound may be set to MUTING.
¢ Your TV may be set to SAP.
¢ SPEAKER may not be set correctly.
¢ Press MUTING.
¢ Check the MTS setting in the AUDIO menu, (page 20).
¢ Check your SPEAKER settings, (page 20).
No color
Color settings may not be adjusted correctly.
Adjust the COLOR settings in the VIDEO menu, (page 19).
Only snow and noise appear on
the screen
¢ Antenna/cable connections may not be correct.
| * CABLE may not be set correctly in the CHANNEL
SET UP menu.
TV may be set to AUX mode.
Ensure that you have selected the correct CABLE mode in |
the CHANNEL SET UP menu, (page 23).
Press ANT on your remote control to change the input
mode, (page 15).

Advertisement

Table of Contents
loading

Table of Contents