Memory Backup Function - Kenwood 106VR Instruction Manual

Remote control unit
Remote control operation is not possible. e Batteries are exhausted
e@ The remote control unit is too far away from the
main system, controlling angle 1s too farge, or
there is an obstacle in between
@ The audio cords and system control cords are
not connected properly
# The source component to be operated does not
contain the tape(s) or CD
@ Anattempt is made to play a tape which is being
106VR/108VR ten}
e Replace with new batteries. 10,
e Operate the remote control unit within the
controllable range. =
@ Connect properly referring to "System con-
nection". ~ 4.
e Place the tapets} or CD in the source compo-
nent to be played.
@ Wait until the recording is completed.
recorded in the cassette deck
Memory backup function
Please note that the following items will be deleted from
this unit's memory if the power cord is disconnected
from the AC outlet or the main power switch is turned off
for approximately three days.
e The power Setting is cleared and the power is set to OFF.
@ The input selection is cleared and the TUNER input 1s selected.
e@The volume setting is cleared and the volume is set to -80 dB
e The receiving band setting is cleared and the FM band is selected.
@ The frequency setting is cleared and 87.5 MHz is selected.
eThe preset station memory is cleared
Do not use contact cleaners because It could cause a malfunction. Be specially careful against contact cleaners containing onl, for
they may deform the plastic components.
«¢ 5
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy Changes or modifications to this equigment may cause harmful interference
unless the modifications are expressiy approved in the instruction manual. The user could lose the authority to operate this equipment if
an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may
cause harmful interference to radio commmunications, if it is not installed and used in accordance with the instructions. However, there 1s
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures.
— Reonent or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
—— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper