Kenwood 106VR Instruction Manual page 16

ROE shoe BAAS Mah AL Hirde
1O6VA / 105VR [Eni
When recording sound with a recorder component of KENWOOD, synchro
recording is possible by setting the INPUT SELECTOR
- to select TAPE1 or MD according to the connected component.
[ Preparation
eSwitcn the VIDEO] display to TAPE1 or MD w+tn the following
Each press switches the arspiay
operation — |
@ Select VIDEO1 with the INPUT SELECTOR. = =
© Press and hold the AUTO key for more than 2 seconds.
iE MIDEON
2 TAPE1 3 MD
To record a music source
Select an input
source other than
TAPE 3
@ Put the cassette deck in record-pause [|
eThe VIDEO! display can be switched to the display of other input by
mode. : using the procedure described in "Preparation" above.
: eFor MD recording, refer to the instruction manual of your MD recorder.
© Play the source and start
g. ;
@ tis Not possibie the VIDEQ1 or MD input to TAPE1 because all of these
Lignts
@ Press the TAPE 2 MONITOR key. :
TUNING | TAPE2
A
=e BAND DISPLAY v MONITOR : STaPe 37 [7
:
; sO O|
7
i
@ Select a source other than TAPE 1. i
INPUT SELECTOR
\
2)
© Play the cassette deck connected to the TAPE 1 jacks and
Regarding TAPE 2 MONITO