Memory Back Up Function - Kenwood 1070VR Instruction Manual

The backlight flashes tive times duringnor- | © Tne patterles are nearing exhaustion. © Replace wit new bateries 10 preserve whe
mal operation. currently registered setup information. +22,
Subwoofer volume cannot be adjusted. Subwoofer is OFF. Turn the subwoofer ON -ae
.
Certain inputs cannot be selected using No preset codes registered at for the respec- Register a preset code or Non-IR code at the
the remote control. tive inputts}. respective inputi(s). ~a,
.
The remote control is set to a different opera- Press VIDEO, AUDIO, or TV to select the
ton mode. approrlate operation mode.
Batteries are exhausted. * Replace with new batteries. If the backup is
exhasted before you can replace the batter-
ies, redo the setup procedure. +22 -Ga
Operate the remote control unit within the
controllable range.
Remote control operation is not possible.
.
The remote contral unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
The audio cords and system control cords are Connect properly referring to "Setting up the
not connected properly. system". -E
* No software is loaded in the source compo- | * Place software in the source component you
nent. want to play.
.
.
An attempt is made to play 2 tape which is Wait until recording has completed.
being recorded in the cassette deck.
The remote control has not been set to the
operation mode for the component you wish
to control.
Press the VIDEO, AUDIO, or TV key to activate
the operation mode for the component you
want to control before operation. -
Do not use contact cleaning agents because they could cause a malfunction. Be specifically careful against using contact cleaning agents
Ig containing oil, oinec they may deform the plaotic components.
For the U.S.A.
eB ae
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. Howover, thor is no guarantes that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna. 7
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio / TV technician for help.
Memory back up function
Please note that the following items will be deleted from
the unit's memory it the power cord is disconnected trom
the AC outlet for approximately 3 days. .
* settings made (ike SUKKUUND SEI UP}.
* Input selector settings.
* Volume level.
* Broadcast band
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
a attention to Article 820-40 of the NEC that provides guidelines for
Re proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close
to the point of cable entry as practical.
+ Frequensy vetting
Preset stations