Rear Panel - Kenwood TS-440S Instruction Manual

3-1-2. -Rear panel
Soo
olfojfoli—>
olfe}folic-—S}
[E> o}fo}fofl=] Tees Ss
ofolfojic| TES c}fol[o][—=>]. [F=>
offo}foJ[=—] E>)
DoS
O}[o]foJI==S] TE 55) olfo]fe]I= a] TE =>)
o}fojjosia—} | E>
o}fo}foj[—] J E=5 o}fo}[o}i—] TEE} offoffoy | T= clfolfoyic
ST TE
@ ACC 3 terminal
Spare RCA type terminal. No internal connections have
been made.
@ AFSK IN terminal
AFSK input terminal.
® AFSK OUT terminal
Constant level AF output terminal for AFSK operation,
@ ANTI VOX control
VOX operations are sometimes difficult with high
speaker volume control settings. The ANTI VOX con-
trol is used to reduce the tendency of the VOX to acti-
vate from inputs from the speaker. The ANT! VOX
control is not active when headphones are connect-
ed, for obvious reasons!
(@®\
@® DELAY control
This control adjusts the "'hang-time" that the radio will
remain keyed after voice input has stopped.
DELAY,
19)
@® VOX GAIN control
This contro} adjusts the sensitivity of the VOX ampli-
fier. Adjust this control for your personal preference.
VOX GAIN
{ YQ'
@ ACC 1 jack
This jack is designed for connection of the 6-pin DIN
connector supplied with the optional interface unit.
EXT. SP (External speaker) jack
This jack is for connection of an external speaker.
@® DC power connector
This fs used to connect the DC power supply.
@ KEY jack f
Using shielded line, connect a 1/4" phone plug to this
Jack for CW operation. Open-terminal voltage is approx-
imately 5.5 VDC.
() ANT (Antenna) connector
This UHF connector should be attached to a suitable
antenna for transmitting and receiving. The antenna ca-
ble should be 50-ohm coax, terminated with a PL-259
connector,
@ GND (Ground) terminal
To prevent electric shock, as well as RFI and BCI, con-
nect the transceiver to a good earth ground.