Yamaha V50 Operating Manual page 38

Settings for 14: Delayl/R & Rev.
Settings for 23: Doubler 2
Parameter Settings
Comment
RevTime | 0.3 sec.—10.0 sec
4
Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
i slower decay.
Lch Diy | 0 ms.—300 ms
Specify the delay time for the teft
channel. As this setting is in-
creased, there will be a longer
wait until the first delayed sound
appears from the left channel.
Rch Dly | 0 ms.—300 ms
Specify the delay time for the
right channel. As this setting is
increased, there will be a longer
wait until the first delayed sound
appears from the right channel.
Settings for 21: Tunnel
Parameter Settings
Comment
|.
RevTime | 0.3 ms—10.0 ms
Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
slower decay.
Settings for 22: Doubler 1
eS
ee
FB Gain | 0%-99%
feedback. As. this setting is in-
creased, there will be more delay
repeats.
Specify the amount of delay
Parameter Settings Comment
H |
DlyTime | 0.1 ms—50 ms
Specify the time until the delayed
sound. As this setting is in-
creased, there will be a longer
wait before the delayed sound
appears.
HPF
160 Hz-
Specify the high pass filter set-
1000 Hz, thru | ting. Frequencies below the
| Specified frequency will be cut.
LPF 1.25KHz--12.0KHz| Specify the low pass filter setting.
Frequencies above the specified
frequency will be cut.
34 Performance Edit
Comment
Specify the delay time for the left
channel. As this setting is in-
creased, there will be a longer
wait before before the delayed
sound appears from the left
channel.
Specify the delay time for the
right channel. As this setting is
increased, there will be a longer
wait before before the delayed
sound appears from the right
channel.
Parameter Settings
Lch Dly | 0.1 ms—50 ms
Rch Dly | 0.1 ms—50 ms
=
LPF 1.25KHz-12.0KHz
Specify the iow pass filter setting.
Frequencies above the specified
frequency will be cut.
Beck E/R
Parameter Settings Comment
LPF 1.25KHz—12.0KHz| Specify the low pass filter setting.
Frequencies above the specified
frequency will be cut.
m
FB Gain | 0%-99% Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats.
Settings for 27: Delay & Tonel, 28: Dly L/R & Tonel, 30:
Delay & Tone2, 31: Dly L/R & Tone2
Parameter Settings Comment
Bril 0-12 Specify the brightness of the
sound. Larger settings will result
i in a brighter sound.
Delay 0.1 ms—300 ms Specify the delay time. As this
setting is increased, there will
be a longer wait before the de-
layed sound appears.
FB Gain | 0%-99%
Specify the amount
feedback. As this setting is in-
creased, there will be more delay
repeats. For a setting of 0%, there
will be no second or subsequent
delay sound.
of delay
3
a