Advertisement
Adjustment
the
middle of a tune, or the stylus descends
outside the disc
circumference, make the necessary adjustment.
1. Adjust to the desired automatic-start position.
2. Check te be sure the automatic-start position is correct.
If when the stylus
descends, the tune
has already started,
Remove the
rubber cap.
¥
=a
RoE
ee
:
soos
Reena
KE
So
POR
Se
ss
See ee te
If noise is heard from new discs, the stylus is probably worn.
Replace it with a new one.
@SIVlUS life. 6 a4 veudn
sovrces a e d eeeeaees approx. 1,000 hours
@NGW GIVIUS cc cate of be cum
durs bbe
eeewee
a eee EPS-30CS
@) Remove the tape on side of cartridge.
@) Pull out
G@) Insert the
new stylus.
Use
a soft brush
or similar
material to gently remove the
dust.
;
Thoroughly
clean your discs
occasionally witha high-quali-
ty disc cleaner.
Carefully...
in arrow direction!
To clean this unit, use a soft, dry cloth.
If the surfaces are extremely dirty, use
a soft cloth, dipped intoa
soap-and-water solution or a weak detergent solution.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol,
paint thinner,
benzine,
nor a chemically
treated cloth to clean this unit.
Such chemicais may damage the finish of your unit.
This adjustment is preset at the factory. This adjustment should
not be necessary unless the cartridge or stylus is changed.
1. Set the cueing control to" Y".
2. Move the tonearm to a position above the disc.
3. Adjust the stylus tip positon.
\
Adjustment screw
RAT
i
i
ee
Sas
The plug-in type of cartridge is already designed to match this
unit in every respect: weight, correct stylus pressure, stylus tip
position, center of gravity, etc. This
means that there's no longer
any
need
for troublesome
connection
cf lead
wires
or
adjustment of the stylus pressure.
G2) Clamp the tonearm.
@) Insert the new
l¢
cartridge by
@ Pulloutthe
following the
cartridge.
Steps. in
@) Remove the screw.
reverse order.
Apply 2 or 3 drops of oil after every 2,000 hours of operation.
(Handle the platter carefully during assembly.)
——
Oil (SFWO 010)
Motor shaft
available from
your audio
dealer.
Advertisement
