Available Accessories Sold Separately - Sanyo VM-EX25P Instruction Manual

AVAILABLE ACCESSORIES SOLD SEPARATELV
The colour monitor remote control can be installed on the
camcorder accessorv shoe to perform the following
functions.
The colour monitor remote control cable is connected to
the REMOTE terminal on the camcorder.
It can be inserted in the accessory shoe facing 4
directions (front, rear, left or right side).
e it can control an auto pan/tilt head
When using the auto panftilt head (model VAH-30, sold
separately), you can control the recording angle from a
distance (using the extension cable supplied with the
remote control) while watching the picture on the
remote control colour monitor.
@ It can be used as a colour monitor (with sound during
playback).
Recording monitoring and playback can be viewed on
the colour monitor.
@ It can perform programmed editing.
Programmed editing allows you to easily select up to 5
segments of a recording to transfer to a new tape.
22
A video light (sold separately) can be installed on the
accessory shoe.
installing the video light
Slide the video light foot (A) into the accessory shoe, until
a click is heard and it is firmly locked into place.
To remove the video light, press and hold button (B), then
pull the video light toward the front.
Using the video light
Set the POWER switch on the camcorder to 'CAMERA',
set the stand-by switch to "STANDBY", then press the
power switch (C) on the video light to turn it on and off.
iF Note: The video light cannot be used if the remote
control is connected to the camcorder.
WARNING:
When the video light is used, it will get verv hot. Be careful
not to get burnt bv touching the front glass or the light
cabinet when the video light is on or just after it has been
turned off.
If the video light bulb is burnt out, have it replaced by the
dealer where it was purchased.
NDA filters available on the market (size: 37 mm), give
good results, when recording on a beach or a ski slope if
the sun is very strong, so that the picture is not over
exposed. For more details, please consult the dealer
where the unit was purchased.
Auto pan/tilt head (VAH-30)