Table of Contents
Advertisement
CAMCORDER OPERATION
When the POWER switch is set to "CAMERA", the
The date and time will be recorded on the tape as
stand-by switch is used as follows:
displayed in the viewfinder. The date and time will not be
A: "STANDBY" position:
displayed if they have not been set. (See pages 14 and
For recording; press the REC START/STOP button to
15.)
start recording or to go into recording pause mode.
Press the DATE button to select the desired displav
B: 'POWER SAVE' position:
mode, as shown below.
When not recording momentarilv; the power to the
viewfinder is cut in order to save the batterv pack
charge.
Recording review
Setting the recording tape speed mode
If the camcorder is in recording pause mode, press and
;
l
release the SCENE SEARCH (~) button once to review, in
When the camcorder is turned on, the SP mode (high
,
eer
the viewfinder, the last few seconds of the recording.
quality recording) is set automatically. No tape speed
Then, the camcorder will automatically return to recording
mode display indicates that the SP mode is selected.
pause mode at the exact point where it previously was.
The tape speed cannot be modified while recording.
A: To set the tape speed
to LP mode, the longest
ig Note: Do not hold the SCENE SEARCH (-) button as
recording duration (double the standard recording
the camcorder will go into scene search mode.
duration), press the SP/LP button for about two
seconds.
If the camcorder is turned off and on again (with the
ii.
ĦU SCENE SEARCH
POWER switch) the tape speed mode is automatically
reset to SP mode.
————_—_—_—_———
>
B: To set the tape speed to SP mode, for high quality
recording, press the SP/LP button for about two
seconds.
0,5
OO
12
Advertisement
Table of Contents
