Table of Contents
Advertisement
INSTALLING THE
LITHIUM BATTERY
After the lithium battery is installed, the time and date will
The linear time counter indicates the tape run time in
need to be set. (See page 15.)
hours, minutes and seconds.
1 Open the lithium battery tray (at the bottom of the
@ Press the COUNTER RESET button to reset the counter
camcorder), using a coin as shown below.
to "0:00:00". If you reset the counter at the beginning of
2 Insert the lithium battery in the tray with the (+) sign
the tape, you can determine the recording duration.
facing up.
e Press the COUNTER MEMO button and "M" is
3 Insert the tray back into the camcorder.
displayed. When "M" is displayed, the "0:00:00" point is
memorized (not the point where the COUNTER MEMO
button was pressed). Press the COUNTER MEMO
button again to erase the "M" and cancel the memory
function.
Using the memory function
1 Press the COUNTER RESET button.
2 Press the COUNTER MEMO button.
3 Set the POWER switch to "PLAYER".
4 Press the REW button. The tape will be rewound and
will automatically stop at the counter reading "0:00:00".
iss Notes:
@ Before use, wipe the battery clean with a dry soft
cloth to assure good contact.
@ Never use metallic tweezers to hold the battery, and
never short circuit the (+) and (—) sides of the battery.
@ Under normal conditions, the lithium battery should
last about 1 year. If the lithium battery is expired
'88:88' will flash in the viewfinder.
WARNING:
@ The lithium battery must only be replaced with a lithium
battery model number Sanyo CR2025 (3 V].
ua Notes:
Use of another lithium battery may present the risk of
@ The lithium battery may present the risk of fire or
chemical burn if mishandled. Do not recharge,
disassemble, heat above 212°F (100°C) or dispose of in
the fire.
14
Advertisement
Table of Contents
