Table of Contents
Advertisement
transportation lock
tabs. Remove before
installation.
mounting Bracket.
lift the power Unit up to
remove.
mains power lead.
Hardwired or unpluggable
depending on the model.
low Voltage Switch Input.
the position of the Switch
Input may vary on different
models.
(See page 8)
Carton Contents
Contents will vary from model to model
Bag adaptoR fits into
the vacuum inlet on the
canister. the bag adaptor
mouth is aligned at 90°
inside the bag.
Bottom BaFFle sits on
the bottom of the canister.
note the correct way up
(shown upside down in
this photo)
iCentral Central Vacuum Systems
your poWer unIt
Inlet plUg
Clamp CoUplIng
used to block the
used to connect
unused vacuum
the muffler to the
inlet on the
exhaust outlet.
canister.
a VaCUUm Bag is supplied with each
power unit. 1 x max-Flo Hepa bag or
1 x iCentral/Valet Universal blue bag
depending on the model
90° elBow for
fitting the muffler.
(Supplied with
some models)
5
InStallatIon Manual
lid with rubber seal. lift
for access to the vacuum
bag. (Bagged units only)
Vacuum inlets.
one inlet is provided on
each side of canister to
cater for left or right hand
duct entry.
an Inlet plug is supplied
to block the inlet not in
use.
exhaust outlet.
ensure that the exhaust
outlet is not placed against
a wall or obstruction which
could impede airflow.
Connect the muffler (if
supplied) to this outlet.
12" mUFFleR connects to the exhaust
outlet.
(Supplied with some models)
Advertisement
Table of Contents
