Table of Contents
Advertisement
operatIng your Central VaCuum system
your central vacuum system has been engineered for a long, trouble-free
service life and is covered by our generous 5 year factory limited warranty.
If your product came with a warranty card, fill it out and mail it within ten (10)
days of installation. Return the card to the free post address on the card or
register your warranty online. Remember, your warranty does not cover abuse
or misuse of the equipment.
Register your warranty online at:
www.icentralsystems.com.au/page/shop/warranty
or
www.valet.com.au/warranty
hoses and CleanIng tools
It is very important to utilise the tool that is designed for a particular cleaning
job in order to obtain full efficiency from your system. there are also a range
other special carpet & flooring tools available, which are not included as part
of the normal tool kits. For example, these include, a vibrating upholstery
tool, a pet grooming tool, and a hand held air turbine. In addition, there are
accessories designed to allow you to safely pick up liquids with your cleaning
system such as the wet pick-Up. each of these tools is available for purchase
from your local dealer.
VaCuum Inlets
when opening the door of the vacuum inlet valve to insert the hose, care
should be taken not to distort the door by forcing it too far open. do not try to
open the door of another inlet while the power unit is running as the suction
may pull the rubber gasket from the door.
If using a standard hose hold the inlet valve's door open for a few seconds
after removing the hose until the suction stops. do not let the flap slam shut
with the motor still running as this may damage the motor or the inlet valve.
If the power unit continues to run after the hose is removed from the inlet,
disconnect the electrical supply to the power unit and notify your local dealer
or serviceman.
poWer unIt motor
Your Power Unit motor uses sealed bearings which require no oil or other
maintenance.
the power Unit, depending on the model, may have a thermal switch, circuit
breaker or fuse which acts to turn off the unit in the event of a power surge
or overheating.
If your unit stops working please consult the troubleshooting guide on pages
18-21 or call your iCentral/Valet service dealer.
16
OWNER'S MaNual
iCentral Central Vacuum Systems
Advertisement
Table of Contents
