Table of Contents
Advertisement
Basic setting
Factory setting
Audible signal
Volume
Button tone
Display brightness
Clock display
Lighting
Operation after switch-
on
Night-time dimming
Brand logo
Fan run-on time
Pull-out system
Sabbath mode
1
Factory setting (may vary according to model)
17 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents supplied by
Home Connect.
¡ Please also follow the instructions in the Home Con-
nect app.
Selection
Reset
1
Do not reset
Short duration (30 seconds)
Medium duration (1 minute)
Long duration (5 minutes)
5 settings
Switched on
Switched off (tone remains
1
for
)
5 settings
Off
1
Digital
Analogue
Off during operation
1
On during operation
Main menu
1
Types of heating
Steam
Assist
1
Switched off
Switched on
1
Display
Do not display
1
Recommended
Minimum
Not retrofitted (if shelf sup-
ports and a single set of
1
pull-out rails are fitted)
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Switched on
1
Switched off
16.2 Changing the basic settings
Requirement: The appliance is switched on.
Press
1.
Press "Basic settings".
2.
1
Press the required basic setting and use the control
3.
ring to change it.
The red bar next to the text field identifies the basic
setting that is currently selected. Its corresponding
value is shown in the display.
Use "Further settings" to scroll through the basic
4.
settings and, if required, use the control ring to
change any of these settings.
To save your changes, press
5.
to confirm.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
Press
▶
a All changes will be discarded and not saved.
16.3 Setting the time
Requirement: The appliance is switched on.
Press
1.
Press "Basic settings".
2.
Press "Time".
3.
Use the control ring to change the time.
4.
To save your changes, press
5.
to confirm.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
Home Connect en
.
and use "Do not save" to confirm.
.
and use "Save"
and use "Save"
23
Advertisement
Table of Contents
