Exchanging The Cylinder; Cleaning, Maintenance, Storage - Grizzly ERV 1400-35 ZV Translation Of The Original Instructions For Use

GB
• Do not use the scarifier in long grass.
It may otherwise wind around the
scarifier blade and result in damage to
the equipment.
• Select the appropriate working or
readjustment position (in the event of
cylinder wear) so that the implement
is not overloaded.
• Commence work in the vicinity of the
power socket and proceed away from
the socket.
• Always ensure that the extension
cable is behind you, and after turning
move it to the side that has already
been treated.
• Guide the implement at a walking
pace down lanes that are as straight
as possible. To ensure uninterrupted
aerating or verticuting the individual
lanes should always overlap by a few
centimetres. Dwelling too long at the
same place while the implement is
running can damage the grass sward.
• To ensure that the extension cable
is not an impediment, turn the imple-
ment in such a manner that the cable
strain release on the bar always faces
the side that has been treated.
After work and to transport the im-
plement disconnect the power plug
and wait until the cylinder is stand-
ing still.
• Adjust the transport position 0 setting
(see "Setting the Working Position")
when transporting the implement.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g.
tiles).
• Always clean the implement after
each use (see "Cleaning, Mainte-
nance, Storage").
56
• After having treated lawns with dense
moss growth, it is advisable to reseed
the lawn so that it can regenerate it-
self quicker.

Exchanging the cylinder

Switch off the implement, discon-
nect the mains plug and wait until
the cylinder is standing still.
Wear gloves when handling the
cylinder.
F 1. Turn the implement over.
2. Release the fastening screw
(25) and fold the bearing cover
(26) away.
3. Tilt the cylinder upwards and
pull the shaft (27) out of its seat.
4. Insert the new cylinder by re-
versing the sequence. Ensure
that the flattened side of the
bearing shell (28) is first inserted
in the bearing.
Cleaning, maintenance,
storage
Work that has not been de-
scribed in these Instructions
must be carried out by a servic-
ing agency authorised by us.
Only use original parts.
Wear gloves when handling the cyl-
inder.
Prior to all maintenance and clean-
ing work always switch off the im-
plement, disconnect the plug from
the power socket and wait until the
cylinder is standing still.