Installing Or Removing; Dust Collection System - Makita HR010G Instruction Manual

9. Do not carry the tool by the attachment device
or the lanyard.
10. Only transfer the tool between your hands
while you are properly balanced.
11. Do not attach lanyards to the tool in a way that
keeps switches or trigger-lock (if supplied)
from operating properly.
12. Avoid getting tangled in the lanyard.
13. Keep lanyard away from the drilling area of the
tool.
14. Use a locking carabiner (multi-action and
screw gate type). Do not use single action
spring clip carabiners.
15. In the event the tool is dropped, it must be
tagged and removed from service, and should
be inspected by a Makita Factory or Authorized
Service Center.
16. Do not hang the tool on your waist. Heated tool
and its accessory may touch your skin and burn
injury result.
1
2
Fig.26
► 1 . Tool hanger 2. Lanyard (tether strap)
DUST COLLECTION
SYSTEM
Optional accessory
The dust collection system is designed to collect dusts
effectively when the concrete drilling operation.
1
Fig.27
► 1 . Dust collection system
CAUTION:
The dust collection system is
intended for drilling in concrete only. Do not use
the dust collection system for drilling in metal or
wood.
CAUTION:
When using the tool with the dust
collection system, be sure to attach the filter
to the dust collection system to prevent dust
inhalation.
CAUTION:
Before using the dust collection
system, check that the filter is not damaged and
the inner pipe is free of dust and foreign matter.
Failure to do so may cause dust inhalation.
CAUTION:
The dust collection system col-
lects the generated dust at a considerable rate,
but not all dust can be collected.
NOTICE:
Do not use the dust collection system
for core drilling or chiseling.
NOTICE:
Do not use the dust collection system
for metal or wood. The dust collection system is
intended for concrete only.
NOTICE:
Do not use the dust collection system
for drilling in wet concrete or use this system
in wet environment. Failure to do so may cause
malfunction.

Installing or removing

NOTICE:
Before installing the dust collection
system, clean the joint parts of the tool and the
dust collection system. Foreign matters on the joint
parts may cause it difficult to install the dust collection
system. If any dust remains on the air duct, the dust
comes into the tool and causes jam in the airflow or
breakage of the tool.
To install the dust collection system, insert the tool
completely into the dust collection system until the tool
is locked in place with a little click.
Fig.28
14 ENGLISH