Makita HR010G Instruction Manual page 12

3. Install the side grip so that the groove on the grip
fit in the protrusion on the tool. Tighten the thumb screw
to secure the side grip.
1
Fig.18
► 1 . Side grip 2. Groove 3. Protrusion
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting the
vacuum cleaner.
1
Fig.19
► 1 . Dust cap
Removing the drill bit
To remove the drill bit, pull the chuck cover down all the
way and pull the drill bit out.
Fig.20
► 1 . Drill bit 2. Chuck cover
2
3
1
2
Removing the dust cup set
To remove the dust cup set, follow the steps below.
1. Loosen the thumb screw on the side grip. Remove
the side grip from the tool.
1
Fig.21
► 1 . Thumb screw
2.
Hold the root of dust cup and pull it out.
NOTE: If it is difficult to remove the dust cup set,
remove the claws of the dust cup one by one by
swinging and pulling the root of the dust cup.
Fig.22
► 1 . Dust cup
NOTE: If the cap comes off from the dust cup set,
place it back to the original position.
12 ENGLISH
1