Removing An Nvme M.2 Carrier Card And Flash Module; Permanently Removing An Nvme M.2 Carrier Card And Flash Module - IBM 9009-41A Manual
Nvme m.2 carrier cards and flash modules
Hide thumbs
Also See for 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Permanently removing an NVMe M.2 carrier card and flash module
from the 9009-41A, 9009-42A, or 9223-42H system
Find information about permanently removing an NVMe M.2 carrier card and flash module from the IBM
Power System S914 (9009-41A), IBM Power System S924 (9009-42A), or IBM Power System H924
(9223-42H) server.
About this task
Note: Installing this feature is a customer task. You can complete this task yourself, or contact a service
provider to complete the task for you. You might be charged a fee by the service provider for this service.
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a
part in the system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).
If you do not have an HMC, complete the steps in the following procedures to permanently remove an
NVMe M.2 carrier card and flash module.
Preparing the 9009-41A, 9009-42A, or 9223-42H system to permanently
remove an NVMe M.2 carrier card and flash module
To prepare the system to permanently remove an NVMe M.2 carrier card and flash module, complete the
steps in this procedure.
Procedure
1. Identify the part and the system that you are working on. For instructions, see Identifying a
part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/sal.htm).
Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number of the
system matches the serial number to be serviced.
2. Stop the system. For instructions, see Stopping a system (www.ibm.com/support/knowledgecenter/
POWER9/p9haj/crustopsys.htm).
3. Label and disconnect the power cords from the system unit.
See Figure 45 on page 52 or Figure 46 on page 53.
Notes:
• This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the system power to be turned off, ensure that all the power sources to the
system are disconnected.
• The power cord (B) is fastened to the system with hook-and-loop fastener (A). If you are placing
the system in a service position after you disconnect the power cords, ensure that you unstrap the
fastener.
NVMe M.2 carrier card and flash modules for the 9009-41A, 9009-42A, or 9223-42H 51
Advertisement
Table of Contents
