Nvme M.2 Carrier Card And Flash Modules - IBM 9009-41A Manual

NVMe M.2 carrier card and flash modules for the
9009-41A, 9009-42A, or 9223-42H
Find information about installing, removing, and replacing an NVMe M.2 carrier card and flash module in
®
the IBM Power System S914 (9009-41A), IBM Power System S924 (9009-42A), or IBM Power System
H924 (9223-42H) server.
Installing an NVMe M.2 carrier card and flash module in the
9009-41A, 9009-42A, or 9223-42H system
Find information about installing an NVMe M.2 carrier card and flash module in the IBM Power System
S914 (9009-41A), IBM Power System S924 (9009-42A), or IBM Power System H924 (9223-42H) server.
About this task
Note: Installing this feature is a customer task. You can complete this task yourself, or contact a service
provider to complete the task for you. You might be charged a fee by the service provider for this service.
If your system is managed by the Hardware Management Console (HMC), use the HMC to install the
part in the system. For instructions, see Installing a part by using the HMC (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/hmcinstall.htm).
If you do not have an HMC, complete the steps in the following procedures to install an NVMe M.2 carrier
card and flash module.
Preparing the 9009-41A, 9009-42A, or 9223-42H system to install an NVMe
M.2 carrier card and flash module
To prepare the system to install an NVMe M.2 carrier card and flash module, complete the steps in this
procedure.
Procedure
1. Identify the part and the system that you are working on. For instructions, see Identifying a
part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/sal.htm).
Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number of the
system matches the serial number to be serviced.
2. Stop the system. For instructions, see Stopping a system (www.ibm.com/support/knowledgecenter/
POWER9/p9haj/crustopsys.htm).
3. Label and disconnect the power cords from the system unit.
See Figure 1 on page 2 or Figure 2 on page 3.
Notes:
• This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the system power to be turned off, ensure that all the power sources to the
system are disconnected.
• The power cord (B) is fastened to the system with hook-and-loop fastener (A). If you are placing
the system in a service position after you disconnect the power cords, ensure that you unstrap the
fastener.
©
Copyright IBM Corp. 2018, 2020 1