IBM 9009-41A Manual page 45

Figure 25. Removing the service access cover
Removing an NVMe M.2 carrier card and flash module from the 9009-41A,
9009-42A, or 9223-42H system
To remove an NVMe M.2 carrier card and flash module from the system, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. For a rack-mounted system, lift the air baffle (A) straight up as shown in Figure 26 on page 32.
For a stand-alone system, remove the air baffle (A) straight out as shown in Figure 27 on page 33.
Place the air baffle upside down on a clean area.
NVMe M.2 carrier card and flash modules for the 9009-41A, 9009-42A, or 9223-42H 31