Desk Mounting; Wall Mounting - BellSouth GH5860 Owner's Manual

5860 man.qxd 11/7/2003

Desk Mounting

Desk Mounting
One of the special features of your telephone is the unique design of the MOUNTING
BRACKET which can hold your phone at an angle of 30° when desk mounting. There are two
positions to choose from:
1. Normal Position (MOUNTING BRACKET not required):
For normal position, as shown in Figure 1, place the
BASE UNIT on any desired but suitable location.
2. 30° Position (See Figure 2):
With the back of the BASE UNIT facing up, insert the
hooks of the MOUNTING BRACKET (with the position
as shown in Figure 3) into the slots of the BASE UNIT.
Then slide the MOUNTING BRACKET upward until it
locks into place

Wall Mounting

You may choose to put the BASE UNIT of your cordless
telephone on a wall.
1. With the back of the BASE UNIT facing up, connect
the SHORT TELEPHONE LINE CORD
TELEPHONE LINE CONNECTION JACK.
2. Insert the free end of the SHORT TELEPHONE
LINE CORD through the hole of the MOUNTING
BRACKET.
3. Insert the hooks of the MOUNTING BRACKET into
the matching slots on the back of the BASE UNIT
(following the position as shown) then slide the
MOUNTING BRACKET until it locks into place.
4. Plug the free end of the SHORT TELEPHONE
LINE CORD into the MODULAR WALL JACK.
5. Align the upper keyhole of the MOUNTING
BRACKET with the upper stud of the wall plate, so
that the opening end of the MOUNTING BRACKET
matches the lower stud, then pull the BASE UNIT
down until it is securely seated.
6. Pull out the HANDSET RETAINER TAB on the
BASE UNIT, then place the HANDSET in the
BASE UNIT CHARGE CRADLE.
5:48 PM Page 18
to
9
the
Cordless Tel