Table of Contents
Advertisement
DSST~2801~A.qxd 1/25/2003 6:46 PM Page 18
Desk Mounting
Desk Mounting
For normal position, place the BASE UNIT on any desired but suitable
location.
Wall Mounting
You may choose to put the BASE UNIT of your cordless telephone on a wall.
1. With the back of the BASE UNIT facing up, connect the SHORT TELEPHONE LINE
CORD to the TELEPHONE LINE CONNECTION JACK.
2. Insert the free end of the SHORT TELEPHONE LINE CORD through the hole of the
MOUNTING BRACKET.
3. Insert the OUTER HOOKS of the MOUNTING BRACKET into the matching slots on the
back of the BASE UNIT.
4. Push the MOUNTING BRACKET upward until the LOCKING HOOKS snaps into the
inner slots of the BASE UNIT.
5. Plug the free end of the SHORT TELEPHONE LINE CORD into the MODULAR WALL
JACK.
6. Align the upper keyhole of the MOUNTING BRACKET with the upper stud of the wall
plate, so that the opening end of the MOUNTING BRACKET matches the lower stud,
then pull the BASE UNIT down until it is securely seated.
9
Cordless Telephone Operation
Preparing for Use
Before you can use your cordless telephone, you must charge the HANDSET for 12 hours.
Failure to do so will require recharging of the BATTERY PACK more often.
1. Place the HANDSET on the BASE UNIT for 12 hours.
2. After 12 hours, remove the HANDSET from the BASE UNIT.
Before you can use your cordless telephone, you must charge the HANDSET for 12
hours. Failure to do so will require more frequent charging of the BATTERY PACK. See
page 39 for more information on the BATTERY PACK.
NOTE:
Depending on the frequency of use, once the HANDSET is fully charged, it remains
functional for approximately 4 hours of continuous use and approximately 5 days when the
HANDSET is off the BASE UNIT in STANDBY mode.
Receiving Calls
When a call is received, all of the HANDSETS registered to the system will ring with the RINGER
LEVEL and MELODY selected by the user. The first HANDSET to respond will get the call.
1. When the phone rings, the LCD Screen of all of the
HANDSETS registered to the system will display
"Ring." If you have Caller ID, the LCD Screen will
display the Caller ID information after the first ring.
2. With the HANDSET on or off of the BASE UNIT, press
the
button. "Talk" will be displayed and the Call
TALK
Timer starts to count. Start your conversation.
3. To end your conversation, either press the
button or place the HANDSET on the BASE UNIT.
The duration of the call will be displayed on the LCD
Screen for about 3 seconds and then returns to the
STANDBY mode.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to warn you
that the background noise level is too high for proper communication between the HANDSET
and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to
reduce the noise level. Otherwise, the call will automatically cut off.
10
TALK
Minutes
Seconds
Advertisement
Table of Contents
