Connect The Printer Via Wi-Fi - Honeywell PC42E-T User Manual

4.
5. Print a test label to find the IP address of the printer. For more information, see

Connect the Printer via Wi-Fi

The printer supports wireless communications when the optional Wi-Fi module is
installed.
You can configure wireless communications:
•
•
By default, the printer supports DHCP networks.
Note: If you are not using a DHCP network, Wi-Fi settings must be configured by using
Honeywell PrintSet 5 through a USB connection to the printer. Send commands
through a serial connection, or use the wizards and settings menus on the printer.
Configure Wi-Fi Communications from the Web Page
Use this procedure to configure wireless communications from the printer web
page. To access the web page, see
on page 26.
Note: The printer must be turned on and connected to your Wi-Fi or Ethernet network to
configure the printer from the web page.
1.
2.
PC42E-T Desktop Printer User Guide
For a non-DHCP network:
• From PrintSet 5, select Configuration > Communications > Ethernet > IPv4
or IPv6 and change the settings as needed.
•
From the web page, select Configure > Communications > Ethernet > IPv4
or IPv6 and change the settings as needed.
Setting
(IPv4) IP Assignment Method
(IPv4) IP Address
Subnet Mask
Default Router
DHCP Response
(IPv6) IP Assignment Method
(IPv6) IP Address
About Test Labels on page 19.
From the printer web page
From PrintSet 5
Open a web browser on your PC.
Click the Configure > Communications > Wireless 802.11. The Wireless
802.11 settings page appears.
Default
DHCP
0.0.0.0
0.0.0.0
0.0.0.0
Broadcast
Automatic
Automatic
Configure the Printer from the Printer Web Page
23