ELPRO CZ40RIPS User Manual page 21

6.5.3 Edit device - Connection status
Displays the current connection status. Tap it to reconnect.
6.5.4 Edit device - Advanced Settings
Go to the advanced settings of the camera.
6.5.4.1 Advanced Settings - Video Quality
Change video quality here. With video quality, the format in pixels is chosen. The larger the format,
the longer the video takes to load and the more memory of the smartphone/tablet is used:
High = 1920 x 1080
Low = 1280 x 720
This information can be seen on live viewing. A quality is also listed here; Good, Normal or Bad.
6.5.4.2 Advanced Settings - Alert Interval / Notifications on Smartphone
Use this setting to set the notifications on the smartphone.
First, you set until how long after the last detection you receive another notification. The following
options are available here:
Always on - 1min - 3min - 5min - 10min - 30min – Off
Example: A person enters the detection area and you receive a notification. The first subsequent
notification only occurs when motion detection occurs again after 3 minutes.
Note!
When you have selected ''Off'', no notifications are sent but motion is detected and stored on the
SD card.
After selecting a Notification interval, it is necessary to also set the monitor correctly. To set this
correctly, the following steps need to be taken:
•
Make sure the sensitivity is set properly via the monitor. To do this, go to Motion
detection (see 5.5.1 Motion Detection Settings - sensitivity) and set the sensitivity to high.
•
Go to the smartphone settings and make sure the ELRO Monitoring 2.0 App has
permission to send notifications.
•
Finally, return to the app. Check the Notification Interval setting again and return to the
dashboard. The settings are saved. It may take some time to process the settings.
- 20 -