Accessory Mounting Rail - Advanced Elements STRAITEDGE ANGLER PRO Owner's Manual

3.2 ACCESSORY MOUNTING RAIL

The Accessory Mounting Rail can be used with any aftermarket 1" round rail mount fishing rod
or accessory holders. The Accessory Mounting Rail does not need to be installed on the kayak if
you are not intending on using it for any rail-mounted accessories.
Installation and Assembly
Make sure to install the Accessory Mounting Rail before inflation.
1. Make sure that the Accessory Mounting Rail is in 3 parts, you should have 2 Mounting Rail
Arms and 1 Cross-bar. If the Accessory Mounting Rail is assembled:
I. Locate the push-buttons at the sockets of the Mounting Rail Arms.
II. Depress the push-buttons and separate the Mounting Rail Arms from the Cross-bar.
2. Once you have the Accessory Mounting Rail in 3 parts, slide the Mounting Rail Arms through
the grommets located at the front of the kayak. Make sure that the push-button sockets are
pointed to the front of the kayak. (See Illustrations 1 and 2)
3. Socket the Cross-bar onto the Mounting Rail Arms. Make sure that the push-buttons pop
up through the holes on the Cross-bar. At this same time, make sure that the pushbuttons are
positioned in between the two grommets, not in front of the forward grommets.
(See Illustrations 1 and 2)
4. To remove the Accessory Mounting Rail, press the push-buttons in at the sockets and separate
the Cross-bar from the Mounting Rail Arms, then slide the Mounting Rail Arms out of the
grommets.
8