American Standard T061901.243 Manual page 4

3
VALVE ASSEMBLY
• Remove Plaster Guards.
• Thread Insert (1) into SIDE VALVE (2) until it touches
the installation surface.
• Thread Insert (3) into SIDE VALVE (4) until it touches
the installation surface.
• Tighten Coupling (5) into tee (6) for products
without hand shower.
4
INSTALL HANDLES
• Turn VALVE to OFF position.
• Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without a spline is facing up.
Fig. A. Tighten STEM SCREW (3) to secure ADAPTER (1).
• Rotate ADAPTER (1) so that the valve is in the off position. Align HANDLE (6) so that it is in the off position
and push the handle assembly over ADAPTER (1). Without rotating the HANDLE (6), thread the HANDLE
BASE (4) on to DECK ADAPTER (5).
Fig. A.
SPLINE END DOWN
B
FITTING
MOUNTING
DECK
VALVE
LOCKING
HOT
TOP
3
1
SPOUT
SHANK
6
5
2
6
4
2
1
5
3
VALVE
LOCKING
COLD
4