Crown Pagoda2 6x6m Instruction Manual page 9

12. As each leg is inserted, attach the metal quick link of the
rope ratchet (part C) to the string on the tent top.
Screw it closed to ensure it won't come off with movement.
IMPORTANT: Do not hook the ratchet onto the D rings or
onto the rope incorrectly. Doing this can cause water pooling
and damage the marquee. See step 17 for more details
13. The rope ratchet should now connect the top and the foot. Pull on the loose end of the rope to tighten it.
Go around and tighten the rope ratchets equally, the black ratchet part should be around half way up the
leg. The foot should be pointed towards the inside (center) of the tent, with the eye nut on the outside (the
below photo is from the outside pointing in). Tighten the rope ratchet by pulling on the loose end until the
rope is taut, but only enough so that the foot cannot fall off the leg.
Standard:
14. Now you need to install the center mast through the tent top. Place the center mast pin at the top of the
center mast pole. Unhook the clip at the bottom of the center mast pole and position the bottom of the
center mast pole onto the top cable. Making sure the mast pin at the top is through the hole and is visible
from the outside of the tent top, slide the center mast pole up the cable toward the intersection of the
cables. Move the center mast pole to the center of the tent making sure it rests on both cross cables. Once in
place, put the clip back on the bottom of the center mast pole making sure it is under both cables to keep it
in place.
Top Cable
Pagoda
INSTALLATION INSTRUCTIONS
XG:
www.crowncanopies.co.uk
© 2020 Crown Canopies PG.9