Crown Pagoda2 6x6m Instruction Manual page 8

8. There are 3 straps for each side that connect the eave pole to the PVC top.
There are a total of 18 straps. Buckle them around the eave pole and tighten
them so they are taut, but not too tight.
IMPORTANT: Having these straps too tight or too loose can result in water
pooling on the roof. Make sure the roof has no areas near the straps where it
can collect water (this is sometimes best viewed from above).
9. Go around each corner knuckle and hook half of the 50mm ratchet (part A
with the black end hook end) over the outside hole of the corner knuckle, let
the rest hang down. Do this for all 4 corners.
10. 1. If your stakes have a welded washer for the 2nd head: Take the short part of the 50mm ratchet strap (part B,
with D ring) and put it on the ground where the stake will go (1.5m away from the leg, away from the centre of the
tent). Twist the nylon webbing around so it is in the corner of the half circle of the D ring as (shown in photo 1 below).
2. If your stakes have a welded nut for the 2nd washer: Knock in the stake as the below instructions and tie the ratchet
underneath the welded nut using a dog leg knot. You can also do this for step 1 (shown in photo 2 below).
Knock in the stake vertically until the lower head / tied strap is 1cm or less to the ground. The strap needs to be no
shorter than 3.4m from the stake to the knuckle, which is just over 1/2 a metre longer than a leg. If it is it will be
impossible to lift the tent. There are 2x 50mm straps per corner, assemble in a triangle with 1.5m between the stakes
and 1.5m between the stakes and the marquee.
This step will minimise the chances of the top blowing away during the rest of the installation
1.
11. Once the top is in place and secured, you're ready to install the legs. Lift on side of the tent up and install two
of the legs at each corner, leaving the tent at an angle. Attach the feet and rope ratchet assembly to each
leg as you install the legs. You can hook the string end with the metal quick link on the O ring of the foot
and then pull it up the leg and hold it all together. This will ensure the feet stay on as you finish assembly.
Then insert 1 more leg so you have 3 legs in place with the tent still at an angle.
INSTALLATION INSTRUCTIONS
1.
2.
XG:
PG.8