Table of Contents
Advertisement
Set Up Instruction
1. Lay out a floor cover in the area the tent will be installed to protect the tent top of dirt and abrasions.
2. Lay out the frame parts on the ground in the approximate location that they will be when the frame is
assembled. (See parts/minimum staking layout diagram)
3. Assemble the 4 complete eave poles using two 2.82m tubes joined together with the joiner.
4. Starting at one corner, insert the assembled eave poles into the corner knuckles.
5. Continue to insert all 4 complete eaves into the corner knuckles until a square is formed.
6. . Connect one cross cable to the inside hook on the corner knuckle. Connect the other end of this cable to the
hook on the corner knuckle at the diagonal corner. Repeat this method to secure other cross cables.
a. . In order to fit the cable onto the 4th corner fitting hook, you may need to lift the frame up on that
corner approximately 4 feet off the ground. This reduces the distance between the corners allowing
the cable to reach the 4th corner fitting hook.
7. Lay the tent top out over the cables and frame with the top of the tent facing upward. Start in one corner by
securing the white nylon strap over the ring on the outside of the corner knuckle.
a. Continue to secure all the tent corner straps to the outside corner knuckle. Make sure the strap
with the O ring is the last strap to be secured. This ring and strap will allow for better grip
when securing the top over the last knuckle.
INSTALLATION INSTRUCTIONS
IMPORTANT: The roof should be gently lifted over the wires
to avoid excessive rubbing. Crown Canopies is not liable for
holes made when dragging the top without due care.
Corner Knuckle
PG.7
Advertisement
Table of Contents
